Cetme buttstock metal....

[concretus]

All the parts except the wood. Anybody????

[Otis61]

I might be able to help you out. Let me take a look, and I'll get back to you.

[LostInTexas]

Look for a used set with bad wood and then rob the metal parts. I would think you could find one for $10 or so. Good luck.

Might also look for an HK set even a plastic set and rob from there with a little modification.

-LIT

[LostInTexas]

Found a complete HK set at cheaper than dirt for $9.97. Their part number is MGR-281.

NOTE: this would require a little modification for a Cetme but not bad at all, less than 5 minutes.

[concretus]

I might be able to help you out. Let me take a look, and I'll get back to you.

Great! Thanks Otis.....

[concretus]

Found a complete HK set at cheaper than dirt for $9.97. Their part number is MGR-281.

NOTE: this would require a little modification for a Cetme but not bad at all, less than 5 minutes.

I have a CETME wood buttstock with some real nice grain.... What mods do you have to do to make it work on H&K metal. I thought it couldn't be done because the CETME buffer hole does not line up with the H&K back plate.

[mightymanx]

I have G3 metal and a buffer Not Cetme though.

[Otis61]

Is yours bad?

[concretus]

No, it's fine. I just wanted another one....