patjsimpson
07-02-2009, 03:58 PM
Hello,
I have a used cetme barrel that was previously match to a different trunnion. I was wondering if rather than trying to drill an oversized pin is it possible to rotate the barrel and repin it with the regular sized pin? Since there is no extractor relief cut into the barrel face I would think this would be ok.
thx
Pat
I have a used cetme barrel that was previously match to a different trunnion. I was wondering if rather than trying to drill an oversized pin is it possible to rotate the barrel and repin it with the regular sized pin? Since there is no extractor relief cut into the barrel face I would think this would be ok.
thx
Pat