SigfanUSAF
05-23-2007, 08:02 PM
Sold Pending Funds!!!!!
I have a JLD receiver for sale, but before you post I'll take it, please read....
I bought this 2 years ago, as a used receiver to build an HK51 clone on. It had a CETME trunnion welded in, and a CETME barrel, so I purchased a Century arms CETME to rob parts out of, and completed the firearm. However, accuracy was crap, so after inspecting the barrel, I found a rather large ring about 6" from the muzzle. Someone had already tried to remove the barrel at some point, as the barrel pin is slightly mushroomed on either side. Also, the holes in the receiver dont exactly line up with the trunnion, though the trunnion is fully seated in the receiver. I suspect there is a difference between a CETME an HKs barrel pin locations. Now, in doing the modification, I cut the cocking slot in the top left portion of the receiver. Other than that, the receiver is in perfect shape, with HK sight base welded on. If you're looking for a project receiver, which may or may not need to have the trunnion replaced, this is it. As I could not get the barrel out, it is cut off directly in front of the trunnion.
I would like to get $100 shipped out of this, to recoup some of my expenditures. Must go to valid 01 FFL. I will also entertain trade offers for 03A3 or M1 Carbine stuff.Sold Pending Funds!!!!!
If you're interested, please email me @
dieselboy_1980@yahoo.com
I will post pics in the morning!!!!
I have a JLD receiver for sale, but before you post I'll take it, please read....
I bought this 2 years ago, as a used receiver to build an HK51 clone on. It had a CETME trunnion welded in, and a CETME barrel, so I purchased a Century arms CETME to rob parts out of, and completed the firearm. However, accuracy was crap, so after inspecting the barrel, I found a rather large ring about 6" from the muzzle. Someone had already tried to remove the barrel at some point, as the barrel pin is slightly mushroomed on either side. Also, the holes in the receiver dont exactly line up with the trunnion, though the trunnion is fully seated in the receiver. I suspect there is a difference between a CETME an HKs barrel pin locations. Now, in doing the modification, I cut the cocking slot in the top left portion of the receiver. Other than that, the receiver is in perfect shape, with HK sight base welded on. If you're looking for a project receiver, which may or may not need to have the trunnion replaced, this is it. As I could not get the barrel out, it is cut off directly in front of the trunnion.
I would like to get $100 shipped out of this, to recoup some of my expenditures. Must go to valid 01 FFL. I will also entertain trade offers for 03A3 or M1 Carbine stuff.Sold Pending Funds!!!!!
If you're interested, please email me @
dieselboy_1980@yahoo.com
I will post pics in the morning!!!!