G-3 Buttstock

[Milsurp]

I'm doing a build and have a JLD g-3 butstock and was wondering if I can use the Cetme buffer on it. What would have to be done to it.

[Seattlefungus]

The buffer plate is different, it will require some fitting. The wood stock CETME's didn't have a buffer. Later synthics did. A better buffer is the JLD PTR91 Comfort, goes for 44.00. Or just buy one of the Cheaper than dirt HK stock sets. Comes with all the metal & buffer for around 20.00... Or better yet go to http://www.robertrtg.com/g3.html and he sells the g3 buffer for $6.00 and you'll know it will fit...

[Hoot]

My wood stocked CETME had a buffer. It was stiff though. I opened it up, cleaned it and put a new aftermarket rubber replacement inside it.

BlackJack Buffers (http://www.blackjackbuffers.com/index.php?main_page=product_info&cPath=65&products_id=187)

Works in a G3 buffer as well. Made an appreciable difference in perceived recoil for my CETME.

Hoot

[Seattlefungus]

I went out and checked both of my wood butt stock models. Nether has a buffer.

[Hoot]

I went out and checked both of my wood butt stock models. Nether has a buffer.

What is holding the buttstock to the recoil assembly without any buffer assembly in them? :blink2:

Hoot

[Seattlefungus]

The plate is screwed from the plate directly to the wood stock. I'l take pictures tomorrow. The buttstock is held by a screw kind of like the FAL, I use a long shank screw driver to take the main screw off. Then there is one small screw inside the stock plate. That's screwed direcly into the wood to...