TS308
03-21-2007, 08:33 PM
Hello,
after splitting a case the other day , i started searching on ways to remove the case i read where you could try a 45 cal brush didnt have one of them but had a 50 cal for my black powder rifles tried that it didnt work , read where you can jam a 12 ga brush in the case tried that and it didnt work , then i read where some one broke 2 extractors on a case from trying to hammer the case out of the chamber well i went ahead and ordered 2 extractors and received them to day Man thats the best 10.00 bucks i ever spent.. so i go get my mallet and insert the extractor first pull on the charging handle didnt do anything but remove the extractor put it back in and cycled the bolt but let it charge home pulled back on the handle and the extractor and case popped right out didnt even have to use the mallet .
here is some pics of the case as well as a couple other nato brass cases that i cut into to see how thick the brass is , i found another WCC 79 and fired it and cut it in half to see how thick it was compared to the one that failed .
cleaned the rifle went out and ran 40 rounds through the rifle , it ran perfect
TS2
http://i20.photobucket.com/albums/b221/bluevtx/Cetme/2006_0611splitcase0002.jpg
http://i20.photobucket.com/albums/b221/bluevtx/Cetme/2006_0611splitcase0003.jpg
after splitting a case the other day , i started searching on ways to remove the case i read where you could try a 45 cal brush didnt have one of them but had a 50 cal for my black powder rifles tried that it didnt work , read where you can jam a 12 ga brush in the case tried that and it didnt work , then i read where some one broke 2 extractors on a case from trying to hammer the case out of the chamber well i went ahead and ordered 2 extractors and received them to day Man thats the best 10.00 bucks i ever spent.. so i go get my mallet and insert the extractor first pull on the charging handle didnt do anything but remove the extractor put it back in and cycled the bolt but let it charge home pulled back on the handle and the extractor and case popped right out didnt even have to use the mallet .
here is some pics of the case as well as a couple other nato brass cases that i cut into to see how thick the brass is , i found another WCC 79 and fired it and cut it in half to see how thick it was compared to the one that failed .
cleaned the rifle went out and ran 40 rounds through the rifle , it ran perfect
TS2
http://i20.photobucket.com/albums/b221/bluevtx/Cetme/2006_0611splitcase0002.jpg
http://i20.photobucket.com/albums/b221/bluevtx/Cetme/2006_0611splitcase0003.jpg