cetme jig

[dungeonwarlock]

How does one get use of a jig to bend a cetme receiver?

[SCGrotz]

from what I gather the most basic "jig" is a pipe and a bench lol

[dungeonwarlock]

I've already picked up a piece of 3/4 rod with intentions of using the 'work bench' jig. The thing that holds me back is that I really want it to turn out well. Using a jig seems to be the most likely method of getting the end product I'm looking for- especially when looking at the ak builds I've done- they worked fine and turned out ok but the learning curve consisted of cleaning up a couple of mistakes and took a little toll on the cosmetics.

Now- since I posted the question of g3 or Cetme and was convinced that the only logical answer is 'both' - I've got another flat and kit on the way. And it seems I've become a perfectionist.

Hmmmm.. that's out of character for me :icon_confused:

[okie shooter]

Try this post, shows the slick setup needed to make these work right.
http://www.militaryfirearm.com/Forum/showthread.php?t=6095

Not sure how you would get the use of such a jig, though, maybe some one might have a flat bending party.