What G3 fcg parts for CETME build?

[ELEFANTMKVI (The Inbred clown)]

Hi, Plan on having a CETME built in the near future. I will be using a G3 lower with JLD trigger box, hammer, trigger and sear.Beside the safety/selector and the ejector assy. What other internal fcg parts will I need? I dont want to have to buy a complete G3 lower for a $100. Just wanted to buy a stripped one and add US compliant and origional G3 parts. Will get the G3 parts from RTG but need to know what to buy. Please advise.:056:

[rustypirate]

The only other thing to add to your list would be the pistol grip and charging handle. Added to a US made receiver, your compliance parts total would be met.

[ELEFANTMKVI (The Inbred clown)]

Rusty, I planned on using those US compliant parts, no problem. What I need to know is what other FCG parts do I need, that are not 922. Such as hammer and trigger springs, ect.,ect. I don't want to buy a complete G3 lower just a stripped one and take it from there, thanks, Mike.

[rustypirate]

Tigger pivot pin, trigger spring, hammer pivot pin, hammer spring, hammer spring shank, sear spring pivot pin, semi-auto sear spring, semi-auto sear spring spacer, ejector lever, ejector spring, ejector pivot pin.

That should do it for the FCG, andall parts are available from RobertRTG.com.

[ELEFANTMKVI (The Inbred clown)]

Tigger pivot pin, trigger spring, hammer pivot pin, hammer spring, hammer spring shank, sear spring pivot pin, semi-auto sear spring, semi-auto sear spring spacer, ejector lever, ejector spring, ejector pivot pin.

That should do it for the FCG, andall parts are available from RobertRTG.com.

Thanks for your help, Once I get these parts all I need is a reciever and can start building.:thumbup:

[Otis61]

I also have a G3 lower that I was going to use ,and don't know where to get the US fcg, or the US charging handle. Does anyone have ideas? Thanks.

[nalioth]

I also have a G3 lower that I was going to use ,and don't know where to get the US fcg, or the US charging handle. Does anyone have ideas? Thanks. www.ptr91.com

[ELEFANTMKVI (The Inbred clown)]

OTIS, Check out some of the other boards also. I got a JLD G3 sear, hammer and cocking handle all US made for under $50.00 for the 3 parts. From a member on the FAL files. Good deals are out there just keep searching. For me that's what makes this hobby so much fun. Just my 2cents.