Results 1 to 2 of 2

Thread: Cocking tube gap bigger than a nickle.

  1. #1
    Veteran stevelkinevil's Avatar
    Join Date
    Mar 2011
    Location
    Colorado
    Posts
    81
    Rep Power
    28

    Cocking tube gap bigger than a nickle.

    Read the instructions posted on checking it and gave er a look, its wider than the width of a nickle (sorry dont have a mic). And it is a bit difficult to unlock, what is the fix for this?
    "those who would trade liberty for safety deserve neither"

  2. #2
    Senior Veteran The Great 308's Avatar
    Join Date
    Mar 2007
    Location
    SE Ohio
    Posts
    1,473
    Rep Power
    90
    Try going back and reading the sticky again including the entire thread. Bladeworks explains all of this stuff much more clearly than I can. There is a post by someone with your exact question in that thread and Bladworks goes into detail about how to correct the problem. Pay close attention to post #13.

    Good luck with it hopefully Bladeworks will chime in.

Similar Threads

  1. Replies: 171
    Last Post: 06-13-2013, 01:23 AM
  2. Cetme bolt Gap and cocking tube gap
    By ojsplatters in forum Cetme/HK
    Replies: 10
    Last Post: 02-03-2012, 11:05 AM
  3. Is there any way to fix low cocking tube gap?
    By Bob The Great in forum Cetme/HK
    Replies: 11
    Last Post: 03-06-2011, 05:13 PM
  4. Cocking tube gap
    By Hickok in forum Cetme/HK
    Replies: 7
    Last Post: 11-03-2010, 04:55 PM
  5. Cocking tube gap
    By Lalvis in forum Cetme/HK
    Replies: 7
    Last Post: 03-22-2010, 12:46 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •