There were no muzzle devices I liked for the WASR 3 that I have. The barrel is too small for the standard 14X1mm LH thread.
So I ordered from Online metals and created the following.
The ports are milled
Rough fit to the FSB
Finished fitting
It will be welded to the FSB so both retain the ability to be removed.
On the muzzle but not painted yet
Trying the MOJO sight on this one
looking good so far! keep us updated, and let us know how you like the mojo sight as well
Is that a ball endmill I see in the first picture? And was the WASR 3 muzzle not threaded?
Neat project, I've been meaning to make some prong hiders for my AKs.
cog member #i
The loon formerly known as skslover.
The WASR3 are not threaded. I turned mine down a bit and used a standard AR 1/2-28 die for a AK74 style brake.
There is always room for another AK or 1911.
As with anything car or gun related, your results may vary!
"There has been a disturbing increase in things I know nothing about."
Mr. Obama: I'll keep my freedom, hard earned cash, and my guns.... you Sir, can keep the Change!
COG# 182, USMC, ret., Upstanding member of WECSOG كافر
Yes, a ball end millOriginally Posted by Simon
this WASR 3 muzzle was too small diameter to thread for the 14 X 1 LH
Last edited by gunnysmith; 08-17-2007 at 10:20 PM.
i love the home brew.
Posting Permissions
Reply With Quote
Bookmarks